EPever DR3210N-DDS Dual Battery 30A MPPT Solar Charge Controller

Write a review
List price: $367.99
$159.99
You save: $208.00 (57%)
Save 57%
DR3210N-DDS
In stock
+

EPEVER DuoRacer MPPT Dual Battery Solar Charge Controller 30 amp 12V 24V Auto, Negative Ground Solar Controller for RVs Campers Caravan Boats Trailer

mppt charge controller 30 amp 12V

Overview:

DuoRacer MPPT charge controller is made for charging two batteries (shown as BATT1 and BATT2 below) at the same time
in a solar system. This controller supports multiple life battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and
Li-NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the start battery (BATT2) system voltage automatically, and trickle charges the battery when the conditions are satisfied.
The controller adopts the advanced MPPT control algorithm,which will minimize the maximum power point loss rate and loss
time,also fast track the maximum power point(MPP) of the PV array, and obtain the maximum energy from solar array under
any conditions. The energy utilization in the MPPT solar system is increased by 20-30% compared with PWM charging method.
When there is no manual operation for a long time, and the charging conditions cannot be reached, the controller will turn to
low-power mode, which reduces the loss and battery power waste to enhance the products life. The system parameters are
shown and set by LED/LCD or the MT11 remote meter (Accessory).
The AES control signal of the car refrigerator is built in the controller, which will supply the surplus solar power to the refrigerator to avoid energy waste. The controller comes with IP33 protection level, which is waterproof and dustproof. Multiple protection features, including battery overcharge protection, over discharge protection, and reverse connection protection of the PV and battery, which effectively ensure the solar system safety, stability, and lifetime.

Specifications:

Brand: EPever 
Lithium Battery ActivationNo Lithium Batteries Activation
 
Battery Voltage12V, 24V
 
Battery Type: Lifepo4 Batteries, Lithium Batteries, Flooded Batteries, Gel Batteries, Lead-acid Batteries, AGM Batteries, User Mode
 
Charging Current: 30 Amps
 
Ground Type: Netagive Ground
 
Solar Panel Max Input: Power500W-1000W
 
Solar Panel Max Input: Voltage100V
 
Warehouse:USA Warehouse, GER Warehouse

30A mppt太阳能充电控制器12V

 
 

Features:

Maximum Power Point Tracking technology with ultra-fast tracking speed and the tracking efficiency is no less than 99.5%
guaranteed.
Advanced MPPT contro
l algorithm to minimize the MPPlost rate and lost time
The wider range of the MPP operation voltage to improve the PV module utilization
Auto control function of charging power & charging current limitation(BATT1)
High quality and low failure rate components of ST, TI and Infineon to ensure the product life
Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life.
BATT1 type can be set via LED/LCD.
Product runs into the low-power mode when there is no manual operation for a long time, and charging conditions are not
satisfied (PV<5V).
100% charging and discharging in operationenvironmental temperature range.
LED and LCD dispiay units selectable.
AES control signal for car refrigerator to avoid energy waste.
Standard Modbus protocol, and RS485 (5V/200mA) communication port for the customer to expand the application area.
 
①Life battery (BATT1) is the energy storage battery for powering the household loads in the off-grid system, which supports Sealed, Gel,
Flooded, LiFePO4, and Li-NiCoMn batteries (the controller can NOT recognize the system voltage automatically).
②Start battery (BATT2) is the energy storage battery which usually built in the vehicle for powering the system such as RV and Boat, and only
supports lead-acid battery (the controller will recognize the system voltage automatically).
NOTE: the BATT1 and BATT2 must be at the same voltage level.
 
Technical specifications:
未标题-1未标题-2
 
 
 

Negative Ground EPEVER MPPT Charge Controller

  • System voltage: 12V /24VDC Auto
  • Rated charge/discharge current: 30A
  • Max Input Power: 390WO(12V) / 780W (24V)
  • Max. PV Open Circuit voltage: 100V
  • Battery type: LiFePO4, Li-NiCoMn, Sealed, Gel, Flooded, User

 

12V mppt solar charge controller 30 amp

LCD Display

  • PV ( Voltage, Current, Kwh ), One key to zero clearing PV energy function.
  • BAT (Voltage, Current, Temperature ), Temp. compensation:-3mV/℃/2V(77℉) (default)
12V mppt charge controller lithium

 

COMMON NEGATIVE

Ensure compatibility with any negative ground system, which is the standard and most conventional way of grounding

epever mppt solar charge controller 30a 12V

 

 

  • Terminal: 6AWG /16mm2 (BATT1), 12AWG / 4mm2 (BATT2), Recommended cable size: 8AWG/6mm2 (BATT1),12AWG/4mm2(BATT2)
  • Red wire connect “+” and Black wire connect “-”, Ensure tighten wires
  • Dimensions: 9.73 X 6.5 X 2.7 in / Weight: 3.85lb
  • ASIN: B085H9W3FF Package including: 1X 30A MPPT Dual Battery Charge Controller • 1XRemote Meter MT11 • 1X Temperature Sensor • 1X English Manual
  • ASIN: B08534T16Q Package including: 1X 30A MPPT Dual Battery Charge Controller • 1X Temperature Sensor • 1X English Manual
30 amp mppt solar charge controller 12V

Electronic Protect Functions:

  • PV reverse polarity / PV short circuit / PV over current alarm protection
  • Battery overcharge /Battery over discharge / Battery reverse polarity protection
  • Load short circuit / Load overload protection / Overheating protection
 

Package include:

1x MPPT 30A controller

1x User manual

No reviews found